01Universal aluminum gate frameThe pre-engineered frame includes the wide lock side plus top and bottom frame components used to create the 8′ × 8′ single-swing gate structure.
02Wide lock side frameThe side frame is designed around common U.S.-size lock hardware so latch and handle planning can be integrated into the gate.
03Closing-side planningConfirm the stopper, receiver and latch condition required for the finished wall-to-wall opening before assembly.
04Receiver-side componentsReceiver-side hardware and support should match the wall construction, latch choice and finished clearance of the 8-foot leaf.
05Hinge hardwareHinge selection must be matched to the final 8′ × 8′ leaf, mounting substrate and required swing. Confirm the correct support hardware before ordering.
06Black ALU20 horizontal slatsThe ALU20 infill is configured for the 8′ × 8′ gate and can be laid out with either 3/8-inch or 1/2-inch spacing, depending on the selected privacy and airflow level.
Wide residential entriesCreate a tall, wide modern entrance with an eight-foot profile and a clean horizontal aluminum rhythm.
Large side-yard accessUse the wide eight-foot opening where larger pedestrian access, equipment movement or broader clearance is required.
Courtyards and garden accessCoordinate the black gate with contemporary landscape walls, fencing and exterior architecture.
Multi-unit propertiesUse a low-maintenance aluminum pedestrian gate where clean appearance and regular access are priorities.
Light-commercial accessA wide architectural access gate for suitable wall-to-wall openings where the supporting structure and hardware are engineered for the larger leaf.
Coastal and humid climatesAluminum avoids iron-oxide rust and is well suited to environments where steel maintenance can become a recurring issue.
01Verify the openingMeasure the opening at the top, middle and bottom and confirm wall-to-wall mounting surfaces are plumb, solid and suitable for the selected hardware.
02Assemble the frameLay out the universal frame components on a protected flat surface and assemble the structure while checking diagonals for square.
03Install ALU20 slatsPlace the horizontal slats consistently using the selected 3/8-inch or 1/2-inch spacing and secure them according to the gate system hardware.
04Set hinge hardwarePosition the heavy-duty hinge system for the required swing direction and verify that the mounting side can carry the assembled gate.
05Set the receiver sideInstall and align the receiver-side components, latch or lock hardware, T-stopper and L-stopper for clean closure.
06Align and testCheck clearances, fasteners, latch engagement and smooth swing through the full arc before putting the gate into regular service.
01Measure wall to wallConfirm the finished opening at multiple heights and account for hinge, latch and receiver-side clearances.
02Select the gapChoose 3/8-inch for a tighter visual rhythm or 1/2-inch for slightly more openness and airflow.
03Confirm swing directionPlan whether the gate swings in or out based on available clearance, traffic flow and local requirements.
04Plan lock hardwareConfirm the latch or lock body, handle clearance and backset before final assembly of the wide side frame.
05Account for leaf size and windAn 8′ × 8′ single-swing gate has substantial surface area. Verify hinge capacity, substrate strength, swing clearance and expected wind exposure before installation.
06Confirm mounting conditionThe standard configuration is wall-to-wall. Concrete-footing projects require the HD post upgrade and should be specified before ordering.