Heavy-Duty ALU20 Black Horizontal Single Swing Gate & Fixed Side Panel Supply in San Jose, CA

The side yard of this San Jose home is a narrow passage between the stucco wall of the house and a block property wall. It is the everyday route for trash bins, garden tools, bikes and deliveries, and it sits in direct view of the front of the property. The opening needed a gate that would be used many times a day, close reliably, and look like part of the modern house rather than a utility afterthought. The opening is also wider than a typical walk-through gate, which is where many side yard gates fail. A wide single leaf hangs all of its weight from one hinge post, and lighter gates slowly sag until they drag on the ground or stop latching. The homeowner wanted a single swing gate that would stay square, give privacy from the street and need almost no maintenance. Aluglobus Aluminum Systems supplied a custom heavy-duty ALU20 single swing gate with a fixed side panel, sized to the opening so the leaf could stay at a practical width while the panel fills the rest of the passage.

Heavy-duty ALU20 profile: The gate is built from ALU20, Aluglobus's heavy-duty aluminum slat profile for gates that carry their weight on one set of hinges. Its stiffer section resists bending and twisting, which is what keeps a single swing leaf flat and square over years of daily use. Single swing leaf plus fixed side panel: Instead of one oversized leaf, the opening is split into a single swing gate and a fixed side panel in the same profile. The leaf stays at a comfortable width for walking through with bins or tools, and the panel closes the remaining gap. Because the panel is anchored, it adds no weight to the hinges. Horizontal slat design: Horizontal ALU20 slats run across the leaf and the panel with tight, even gaps. From the street, the gate reads as one dark, linear surface that blocks most of the view into the side yard while still letting some air and light through, so the passage does not feel closed in. Heavy-duty adjustable hinges: The leaf hangs on heavy-duty adjustable hinges, so the gate can be fine-tuned during installation and over time to keep even gaps along the hinge side, the latch side and the top. Single-side latch: One latch on the closing side keeps the hardware simple and uncluttered. There are fewer parts to line up and wear, the slat pattern stays clean, and the gate latches with a gentle push. Black powder-coated finish: Black is a custom finish on ALU20. The gate and panel are finished in a textured matte black through Aluglobus's 7-stage powder coat process, which hides everyday dust and scuffs better than lighter colors and matches the dark window frames of the house. Prefabricated for a clean install: Aluglobus supplied the gate and panel built to the measured opening, with the hinge and latch positions planned in advance, so the installer could hang the gate without on-site cutting or guesswork.

The side yard now has a gate that looks deliberate from the street. The black horizontal slats form a clean band between the house and the property wall, and the gate and fixed panel read as one continuous design across the passage. Day to day, the gate swings freely, closes onto the single-side latch without lifting or forcing, and keeps even gaps around the leaf. The narrow slat spacing keeps bins, hoses and storage out of view from the sidewalk. Because the system is powder-coated aluminum, there is no wood to rot or warp and no steel to rust. A rinse with a hose and a quick check of the hinges and latch once or twice a year is all the routine care it needs in the San Jose climate.