Black ALU40 horizontal slat single swing gate with keyed lever between stucco wall and stone column in Huntington Beach
ALUGLOBUS PROJECT
GateInstallation + Supply Huntington Beach, CA

Custom ALU40 Black Horizontal Single Swing Side Gates โ€“ Supply & Installation in Huntington Beach, CA

Aluglobus Aluminum Systems supplied and installed custom ALU40 aluminum side gates for this Huntington Beach, CA home in October 2026. Each single swing gate pairs black horizontal slats with a full perimeter frame and a keyed lever handle, with matching side infill panels where needed, giving the stone and stucco exterior clean lines and a custom fit.

PROJECT FILE ALU40 / Black Aluminum Gate Huntington Beach, CA
LocationHuntington Beach, CA
SystemALU40, Black Aluminum Gate
MaterialArchitectural aluminum
FinishBlack
ApplicationPrivacy, Residential
Project RoleInstalled by Aluglobus
CompletionOctober 2026
01
THE PROJECT

This Huntington Beach home is built from a rich mix of materials: textured cream stucco, stacked natural-tone stone on the walls and columns, crisp white trim and copper gutters and downspouts. The side yards run between those walls on concrete walkways, and each passage needed a gate of its own. These are the everyday routes to the backyard, so the gates had to be easy to open, secure when closed and private enough to keep the side yards out of view. The homeowner's brief came down to two ideas: clean lines and a custom fit. Off-the-shelf gate panels rarely fit openings framed by stone columns and stucco walls, and leftover gaps at the hinge side or the latch side make a gate look like an afterthought. A busy design would also compete with the stonework instead of framing it. The goal was a set of gates that read as part of the architecture: dark, simple and precisely sized to each opening, in a material that holds up to coastal sun and salt air without repainting. Aluglobus Aluminum Systems supplied and installed the complete gate package for the project.

02
THE DESIGN

ALU40 horizontal slat system: Every gate is built from the ALU40 aluminum slat profile, the same system used on the Aluglobus San Diego double swing gate and Miami fence projects. The slats run horizontally across each leaf with tight, even gaps, so the gates read as solid dark panels with thin lines of light rather than open views into the side yard. Full perimeter frame: Each leaf is enclosed by a full aluminum perimeter frame with 45ยฐ mitered corners. The frame holds every slat edge in place, keeps the leaf square and gives the gate a finished, architectural border that lines up with the posts and walls around it. Single swing layout: Each side-yard opening is closed with one full-frame leaf instead of a pair. A single swing gate keeps the hardware simple, opens with one hand and suits the walkway widths on this property. Matching side infill panels: Where an opening was wider than the gate leaf, a narrow fixed ALU40 infill panel in the same black finish and slat spacing fills the space between the gate post and the stucco wall. The slat lines continue across the panel, so the gate and panel look like one designed piece. Locking hardware: Each gate is fitted with a keyed lever handle set on a slim black backplate, with a deadbolt above the lever for a second locking point. The lever opens the gate in one easy motion, and the keyed deadbolt lets the homeowner lock each side yard. A black cane bolt at the base of the leaf drops into the ground to hold the gate steady in position. Custom fit to stone and stucco: The gates were sized to each opening, so the frames sit cleanly between the stone columns, stucco walls and posts. Square black aluminum posts and black hinges disappear into the finish, keeping the attention on the stone. Black powder-coated finish: Black is a custom finish on the ALU40 system. Slats, frames, panels and posts are finished through Aluglobus's 7-stage powder-coating process with AkzoNobel powders for an even, durable coat that contrasts with the cream stucco and warm stone and echoes the home's dark accents.

03
THE RESULT

The side yards now look as considered as the front of the house. Against the cream stucco and natural stone, the black gates read as crisp, graphic panels, and the horizontal slats add a calm, modern line without competing with the stonework. Where an infill panel was needed, the slat pattern carries straight across, so each opening looks like one continuous design. Day to day, the gates are simple to live with. A turn of the lever opens each one, the keyed deadbolt locks the side yard when the family is away, and the tight slat spacing keeps bins, storage and the backyard out of view from the street. Because the gates are aluminum with a powder-coated finish, there is no wood to rot, split or warp in the coastal air and no steel to rust. An occasional freshwater rinse to clear salt and dust, plus a periodic check of the hinges and handle hardware, is all the routine care they need.

04
PROJECT NOTES / FINAL THOUGHTS

Why aluminum works for Huntington Beach side yards: Homes near the coast face year-round sun, marine moisture and salt in the air. Wood gates can fade, swell, warp and need regular sealing, and steel can rust wherever its coating is scratched. Aluminum does not rust the way steel does, and a quality powder coat adds a barrier against UV and salt moisture, which makes it a practical choice for gates that are used every day. Why the full perimeter frame matters: A gate leaf hangs all of its weight from the hinge side. A full perimeter frame with mitered corners ties every slat into one rigid, square unit, which helps the leaf resist racking and sagging over time. Correct post alignment and hinge setup matter just as much. Single swing or double swing: For a typical side-yard walkway, one leaf is simpler, needs less hardware and opens with one hand. When an opening gets wide enough that a single leaf would be heavy or swing into a tight space, a double swing gate splits the width into two lighter leaves. Matching gates to stone and stucco: Black slat gates contrast cleanly with light stucco and warm stone and tie in with dark trim, windows and fixtures. Keeping the gates, infill panels and posts in the same profile, finish and slat spacing is what makes each opening look intentional. How custom-fit gates are sized: Measure the clear opening between the posts or walls, the finished height you want and the direction the gate should swing, and note anything in the way, such as downspouts, slopes or steps. Photos of the opening help the team confirm the right gate and panel layout. Local codes and HOA rules vary: Requirements for gate and fence height, placement and pool barriers depend on the property. Check with the City of Huntington Beach and your HOA before ordering. Planning your next project? Send your dimensions, photos, and ZIP code for a factory-direct supply quote at aluglobusfence.com/online-quote/, call (888) 876-3006 or message WhatsApp 1 (424) 522-2143.

FREQUENTLY ASKED QUESTIONS

PROJECT FAQ

Who supplied and installed the side gates for this Huntington Beach project?

Aluglobus Aluminum Systems supplied and installed the custom ALU40 black horizontal single swing gates, with matching side infill panels and keyed lever handle sets with deadbolts, for this Huntington Beach, CA home in October 2026. Aluglobus manufactures its aluminum gate and fence systems and supplies them factory-direct across California, Florida and Hawaiสปi.

Is an aluminum gate a good choice near the ocean in Huntington Beach?

Yes. Aluminum does not rust like steel or rot, swell and warp like wood, so it handles salt air and marine moisture well. A powder-coated finish adds UV and moisture protection. Rinsing the gate with fresh water now and then removes salt buildup and keeps the finish and hardware looking new.

Does a full perimeter frame stop an aluminum gate from sagging?

A full perimeter frame is one of the best defenses against sag. It locks every slat into a rigid, square leaf, so the gate resists racking under its own weight. Strong posts, correct hinge placement and proper alignment still matter, but a framed leaf holds its shape far better than loose slats.

Is a keyed lever handle with a deadbolt more secure than a basic gate latch?

Yes. A basic gravity latch only keeps a gate closed, while a keyed lever handle set with a deadbolt lets you lock it. The lever is easy to use with full hands, and the deadbolt adds a second locking point. For side yards that lead straight to the backyard, that adds real peace of mind.

How do I order a custom-fit aluminum gate for my opening?

Measure the clear width between the posts or walls, the height you want and the direction the gate should swing. Then send those dimensions, a few photos of the opening and your ZIP code to Aluglobus through the online quote form for a factory-direct supply quote on the right gate and panel layout.

HAVE A SIMILAR PROJECT?Send us your photos, dimensions or drawings.
START YOUR PROJECT
03 / SYSTEM DETAILS

SPECIFICATIONS

System ModelALU40 horizontal slat aluminum system
Type of ProjectSupply & Installation
ConfigurationFull-frame single swing pedestrian gates + matching fixed ALU40 side infill panels where required
FrameFull perimeter aluminum frame with 45ยฐ mitered corners
InfillHorizontal ALU40 aluminum slats with tight, even gaps
HardwareKeyed lever handle set with deadbolt on a slim black backplate; black cane bolt at the base of the leaf
PostsSquare black aluminum posts
FinishBlack (custom on ALU40), 7-stage powder coat
ApplicationResidential side-yard entries, privacy
Project DateOctober 2026
Need help selecting the right configuration?TALK TO ALUGLOBUS โ†’
04 / PROJECT LOCATION

HUNTINGTON BEACH, CA

Explore the project area at city or regional level.

START YOUR PROJECT

BUILDING SOMETHING SIMILAR?

Tell us what you are planning. Send the basics now and our team can follow up for photos, measurements, drawings or plans.

Prefer to speak with us?(888) 876-3006
NEXT STEP

READY TO MOVE FORWARD?

Start with your project details and we can help identify the appropriate aluminum system and configuration.

Get Wholesale Pricing

Contractor or dealer pricing, or our full e-catalog. Tell us what you need and our wholesale team will get back to you.

10% off Premium Aluminum Woodgrain Collection

Limited Promotional Inventory

CONTRACTORS ONLY

Claim Your 10% Off

Send us your information and our team will help you check available woodgrain colors, profiles and current promotional inventory.

Valid on qualifying projects only. Minimum project value required. Restrictions may apply.

Aluglobus Aluminum Systems (White)

Wholesale buyers get $150 OFF their order for a limited time.

Factory-direct pricing. Contractor-ready systems. Limited-time promo.

No stacking with other discounts.

Request a call
Just leave a request and we will provide you with professional advice.
Leave your request
Leave a request and we will contact you within 15 minutes.